Matters needing attention in the production of organic fertilizer granulator

Organic fertilizer granulator is specialized in organic fertilizer granulation equipment. Organic fertilizer granulator equipment is the key link in the entire organic fertilizer production line. The quality of granulation effect directly affects the quality of organic fertilizer. In the organic fertilizer granulator we should follow the following principles:


Matters that organic fertilizer granulator machine should pay attention to when making granules
(1) At least two powder silos to be granulated should be equipped so that the granulator does not need to be stopped when the formula is changed.
(2) Before the material enters the granulator, an efficient iron removal device must be installed to protect the pelletizer.
(3) The organic fertilizer granulator is best placed directly on the cooler, and the crusher is placed below the cooler.
(4) In order to prevent the particles from falling from the bottom of the warehouse to avoid damage, a vertical spiral chute is arranged in the warehouse.
(5) Packing of finished products should be placed after the finished product warehouse.

Daily maintenance of organic fertilizer granulator machine:
1. During the installation of organic fertilizer granulator, the main body should be vertical to the horizontal. The equipment should be installed on the horizontal concrete foundation and fixed with anchor bolts.
2. After installation, check whether the bolts in each part are loose and whether the main engine compartment door is fastened. If so, tighten it.
3. The shaft of the bearing crusher bears the full load of the negative machine, so good lubrication has a great relationship with the bearing life. It directly affects the service life and operating rate of the machine. Therefore, the injected lubricant must be clean and the seal must be good.
4. Bearing oil temperature rises, the reason for stopping the inspection immediately should be eliminated
5. Pay attention to whether the parts of the machine are working properly
6. If there is an impact sound when turning the gear, it should be stopped immediately for inspection and eliminated.
7. Configure the power cord and control switch according to the power of the device
8. Pay attention to the degree of wear of the wearing parts, and pay attention to replacing the worn parts at any time.
9. After the inspection is completed, carry out a no-load test run, and the test run can be carried out normally.